AOSEPT HYDRAGLYDE - 360 ml ALCON

Lens wearers with sensitive eyes who prefer a peroxide system experience the dryness and irritation associated with the combination of lens and cleaning solution

1. Wash your hands and dry them with a clean towel.2. Open the basket marked "L" and place your left lens on the curved part. Close the basket, taking care not to pinch the lens.
2. Repeat the operation with your right lens on the curved part of the other basket marked "R".
3. Open the top cap of the AOSEPT PLUS bottle, then fold it back and away from you.
4. Rinse the lenses in the baskets thoroughly with AOSEPT PLUS for 5 seconds.
5. Fill the case with AOSEPT PLUS solution up to the mark. DO NOT FILL ABOVE OR BELOW THE MARK.
6. Place the basket in the AOSEPT PLUS case and close it. Do not shake the case.
7. Keep the case in an upright position.

- If bubbles escape through the opening in the lid, there may be some un-neutralized AOSEPT PLUS solution remaining. Empty the solution from the dip case and clean up any solution that may have overflowed onto the surface on which the AOSEPT PLUS dip case was placed. Rinse the AOSEPT PLUS case and the AOSEPT PLUS lens holder with sterile saline solution. If any solution overflows, clean immediately with a paper towel. Wash your hands thoroughly before handling your lenses or touching your eyes. REPEAT THE ABOVE DECONTAMINATION OPERATION. 9. Soak lenses for a minimum of 6 hours or overnight to neutralize the solution. 10. Remove your lenses from the lens basket. 11. Your lenses are now ready to wear. 12. Discard the used solution and rinse the AOSEPT PLUS case and lens holder basket with sterile saline solution. DO NOT USE TAP WATER OR NON-STERILE WATER. 13. Let them air dry by turning the lens holder upside down out of the case. 14. If you do not intend to wear your lenses immediately after decontamination/neutralization, you can store them for up to 14 days in the neutralized AOSEPT PLUS solution in the unopened case. After this period, your lenses must be cleaned and decontaminated again with AOSEPT PLUS before being worn. Depending on your ophthalmologist's recommendations, you may wish to rinse your lenses with saline solution before insertion.

Hydrogen peroxide 3%, phosphoric acid, sodium chloride, phosphate buffer, poloxamer, HydraGlyde® Moisture Matrix (polyoxyethylene-polyoxybutylene)